Guest Paul Alexander Posted August 8, 2019 Posted August 8, 2019 Would it be possible to add the ability to click, drag and select a whole bunch of nodes etc to select them in a PCF or BPM editor please? Or, if I've added a load of nodes to a Group Box, to be able to select that Group Box, press delete and for it to delete the box AND all the nodes inside it? thanks!
James Ainsworth Posted August 8, 2019 Posted August 8, 2019 Hi Alexander, The BPM and PCF are part of the Administration portal. I'll move this post to the correct topic. This helps by making sure that those involved in that area see the post as they may not be following Service Manager. Regards, James
James Ainsworth Posted August 8, 2019 Posted August 8, 2019 You can already select multiple nodes by holding down the CTRL key and then click on each node. 1
Guest Paul Alexander Posted August 8, 2019 Posted August 8, 2019 Hi @James Ainsworth Thanks for that....I do already use the ctrl-click but I quite often need to get rid of quite big chunks of a BPM (normally because I've made a bit of a mess!) and the click/drag selection would make my life a lot easier (not as easy as learning to NOT make mistakes, but I know which of these two options is more likely to happen )
SimonSheldon Posted August 8, 2019 Posted August 8, 2019 Ah... I didn't know that so that's good to know!
Guest Paul Alexander Posted November 8, 2019 Posted November 8, 2019 Hi ....have there been any more thoughts on clicking /dragging/selecting and deleting entire group boxes please?
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now