New Board view - waste lane?

[Adrian Simpkins]

Hi All

Just looking over the new view of the boards - I noticed when going into my existing Hornbill board the Waste lane did not show so I moved back to the existing view then back to test view and the waste lane appears but it is in the wrong location? Normally my waste lane are always on the far right lane. I was not sure if this was known but thought I would mention it here

Many thanks !

New view:

Old view:

[TrevorHarris]

Hi @Adrian Simpkins

I think the waste lane in the old view are automatically shift to the last lane, this may not be the case in the new view where it can be positioned anywhere.  You should be able to move the waste lane in the new view to the end in the design mode by dragging it.

Thanks

Trevor 

[Berto2002]

I saw more-or-less the same thing:

In the new preview, the Waste lane appeared to move from being the last to the fourth column. When I switched back, though, it went back to the end where it was.

In the new preview, I moved it back to the end using Design Board and it stuck; so this appears to be a (minor) migration issue.

[Adrian Simpkins]

Thanks Trevor - I will check the boards when its made live then, just a shame doesnt keep the config as is !

Many thanks