fault? Branch not...branching

[QEHNick]

I have recently modified a PC to incorporate a new branch. However, the process completely ignores it.

It's not a complicated "Goto If" (if answer = Yes), and yet it fails to register it completely.

I've done loads of these before so I'm at a loss as to why it's behaving like this.

[QEHNick]

It goes straight through to the "Cost Centre" node if that helps.

 

[Steve Giller]

There isn't a direct path to the CostCentre node - is there any issue with the Mobile Device Details node itself?

Also - what's the first node on the Alertive Capture?

[QEHNick]

Heya @Steve Giller, When I say "it goes straight through...", I mean that's what it does instead of what it should do.

The Mobile Device Node...

And the first node in Alertive (excluding "Start").

[QEHNick]

@Steve Giller I've resolved the issue by removing the "Mobile Device Details" node and recreating it.

That node was copied from another node and modified.

This goes towards confirming an issue I reported in this thread.