Jump to content
Paul Alexander

Drag and select in designer

Recommended Posts

Would it be possible to add the ability to click, drag and select a whole bunch of nodes etc to select them in a PCF or BPM editor please? Or, if I've added a load of nodes to a Group Box, to be able to select that Group Box, press delete and for it to delete the box AND all the nodes inside it?

thanks!

 

  • Like 1

Share this post


Link to post
Share on other sites

Hi Alexander,

The BPM and PCF are part of the Administration portal.  I'll move this post to the correct topic.  This helps by making sure that those involved in that area see the post as they may not be following Service Manager.

Regards,

James

Share this post


Link to post
Share on other sites

You can already select multiple nodes by holding down the CTRL key and then click on each node.  

  • Like 1

Share this post


Link to post
Share on other sites

Hi @James Ainsworth

Thanks for that....I do already use the ctrl-click but I quite often need to get rid of quite big chunks of a BPM (normally because I've made a bit of a mess!) and the click/drag selection would make my life a lot easier (not as easy as learning to NOT make mistakes, but I know which of these two options is more likely to happen ;) )

 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...